HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2012
- HINT:
- Use the following procedures to troubleshoot the wide view front monitor system.
- *: Use the intelligent tester.
- Use the following procedures to troubleshoot the wide view front monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
Measure the battery voltage with the engine switch off.
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system (Click here).
Result Result
Proceed to
Navigation system is normal
A
Navigation system is abnormal
B
|
|||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- for LHD: Click here
- for RHD: Click here
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output (for LHD)
B
CAN DTC is output (for RHD)
C
- for LHD: Click here
|
|||||
|
|||||
| |||||
| 5.CHECK DTC OUTPUT* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests. (Click here).
- NOTICE:
- The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
System
Proceed to
Parking Assist Monitor System (w/ Side Monitor System)
Click here
Side Monitor System
Click here
Result Result
Proceed to
No DTC is output
A
DTC is output
B
|
|||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||