2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT POWER BACK DOOR MAIN SWITCH

B232442E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6(MSE) - 9(MSW)
    Not pushed (on)
    Below 1 Ω
    6(MSE) - 9(MSW)
    Pushed (off)
    10 kΩ or higher

    If the result is not as specified, replace the power back door main switch.

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → terminal 8(ILL+)
    Battery negative (-) → terminal 7(ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Power Back Door Main Switch)
    *b
    Not pushed (on)
    *c
    Pushed (off)

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →