2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT DOOR CONTROL SWITCH

  1. B302191E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (E) - 6 (CSW)
    Pushed (on)
    Below 1 Ω
    3 (E) - 6 (CSW)
    Not pushed (off)
    10 kΩ or higher

    If the result is not as specified, replace the door control switch.

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → terminal 5 (ILL+)
    Battery negative (-) → terminal 4 (ILL-)
    Illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Door Control Switch)
    *b
    Not pushed (off)
    *c
    Pushed (on)

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →