2011-2013 Land Cruiser · Service Manual Brake

C1440 Steering Angle Sensor Unusual Bank Angle Detected

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

If the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (master cylinder solenoid) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.

HINT:
DTC C1440 and the yaw rate sensor assembly DTC are stored when the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:
  1. The yaw rate sensor assembly is installed at an angle.
  2. The yaw rate sensor assembly signal output is stuck.

DTC Code
DTC Detection Condition
Trouble Area
C1440
Driving at a steep bank angle
Yaw rate sensor assembly

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Perform a road test.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC C1440 is output
    A
    DTC C1440 is not output
    B
    Yaw rate sensor assembly DTC is output
    C



B
END

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2. CLEAR DTC
  1. Clear the DTC (Click here).

    HINT:
    1. If the skid control ECU (master cylinder solenoid) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (master cylinder solenoid) stores DTC C1440 while VSC operation is temporarily disabled.
    2. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.


NEXT

END


← C1439 Steering Angle Sensor Initialization Incomplete (+ C1445) (from Jan 2012)C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (from Jan 2012) →