2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR (for Bank 2)

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is gray.


2. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR (for Bank 1)

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is white.


3. INSTALL EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the 2 exhaust gas temperature sensors.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is pink.


4. INSTALL MONOLITHIC CONVERTER ASSEMBLY
(Click here)

5. INSTALL NO. 4 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. Using a 14 mm union nut wrench, install the 2 No. 4 exhaust gas temperature sensors.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The identification tape on the exhaust gas temperature sensor is gold.


6. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
(Click here)
← INSPECTION (from Jan 2012)INSPECTION (from Sep 2011) →