C1612 IG Voltage is Low or High
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
This DTC is stored if the parking assist ECU judges as a result of its self check that the voltage received by terminal IG is low or high.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1612 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (Click here).
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC C1612 is not output.
- HINT:
- If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND) |
Disconnect the parking assist ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F75-4 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F75-8 (IG) - F75-4 (GND1)
Engine switch on (IG)
11 to 14 V
| *a |
Front view of wire harness connector (to Parking Assist ECU) |
|
|
||||
| OK | ||
| ||
