2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2012


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Parking Assist Monitor System / DTC.

  5. Check the details of the DTCs (Click here).

    HINT:
    Parking assist ECU may output the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
    System
    Proceed to
    Parking assist monitor system (w/ Side Monitor System)
    Click here
    Wide view front monitor system
    Click here


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Operate the intelligent tester to clear the codes. Enter the following menus: Chassis / Parking Assist Monitor System / DTC.

  5. According to the display on the intelligent tester, select the trouble code data display with the clear button.

← DIAGNOSIS SYSTEM (from Jan 2012)DIAGNOSTIC TROUBLE CODE CHART (from Jan 2012) →