2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Multi-media Interface ECU Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit provides power to the multi-media interface ECU.

WIRING DIAGRAM

E180194E24

INSPECTION PROCEDURE


1. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E182617E29
    Disconnect the L40 multi-media interface ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L40-12 (+B) - L40-7 (GND)
    Always
    11 to 14 V
    L40-11 (ACC) - L40-7 (GND)
    Engine switch on (ACC)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Multi-media Interface ECU)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - RADIO RECEIVER ASSEMBLY)
  1. Disconnect the F55 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L40-11 (ACC) - F55-11 (ACC)
    Always
    Below 1 Ω
    L40-12 (+B) - F55-12 (+B)
    Always
    Below 1 Ω
    L40-7 (GND) - F55-7 (GND)
    Always
    Below 1 Ω
    L40-11 (ACC) - Body ground
    Always
    10 kΩ or higher
    L40-12 (+B) - Body ground
    Always
    10 kΩ or higher
    L40-7 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Stereo Component Amplifier Power Source Circuit (from Jan 2012)Multi-media Interface ECU Power Source Circuit (from Jan 2012) →