2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

HINT:
  1. Use the following procedure to troubleshoot the G-BOOK system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CHECK PROBLEM SYMPTOM
    1. The G-BOOK system provides a variety of functions. Therefore, it is important to identify whether a malfunction is related to the communication system, including radio wave conditions, or any other systems. Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal condition caused the malfunction.

      Displayed Message and Problem Symptom
      Cause
      A message is displayed temporarily indicating to try again after moving the vehicle because the center cannot be accessed, as the screen cannot be displayed due to a busy line, etc.
      This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
      A message is displayed temporarily indicating to try again after waiting for a while because the information cannot be retrieved due to a busy line, etc.
      This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).
      A message is displayed temporarily indicating to try again after waiting for a while because the lines are busy.
      This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunctions and ask them to use the system as is).

    NEXT

    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      ResultĀ 
      Result
      Proceed to
      CAN communication system DTC is not output.
      A
      CAN communication system DTC is output.
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      ResultĀ 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      CAN communication system DTC is output.
      B

      HINT:
      If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms (Click here).


    B.
    A

    6.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    7.CHECK CIRCUIT
    1. Adjust, repair or replace as necessary.

      NOTICE:
      If the multi-media module receiver assembly is replaced, perform the vehicle contract setting (Click here).

    NEXT

    8.PERFORM CONFIRMATION TEST
      NEXT

      ← SYSTEM DESCRIPTION (from Jan 2012)REGISTRATION (from Jan 2012) →