2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. B310792
    Remove the 3 bolts and 2 screws.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.


2. REMOVE FRONT FENDER APRON TRIM PACKING A

  1. A177003
    Remove the 3 clips and front fender apron trim packing A.


3. DISCONNECT FRONT FENDER LINER RH

  1. A218486
    Remove the screw, and disconnect the liner from the front bumper cover.

  1. Using a T30 "TORX" socket, remove the 2 screws.

  1. Remove the 4 clips.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.


4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE

  1. A266118
    Inside engine room:

    1. Slide the clip and disconnect the No. 3 air injection system hose from the air tube.

    2. Detach the clamp and disconnect the No. 3 air injection system hose from the clamp.

  1. A266119
    Inside front fender RH:

    1. Detach the clamp from the air pump bracket.

    2. Slide the clip and remove the No. 3 air injection system hose.


5. REMOVE AIR PUMP ASSEMBLY

  1. A266120
    Disconnect the connector.

  1. Detach the connector clamp from the bracket.

  1. Disconnect the wire harness from the clamp.

  1. A266121
    Remove the 2 bolts, 2 nuts and air pump assembly.


6. REMOVE AIR PUMP INLET

  1. A273606
    Remove the 2 bolts and air pump inlet.


7. REMOVE NO. 1 AIR INJECTION SYSTEM HOSE

  1. A219186
    Remove the No. 1 air injection system hose from the air pump assembly.


8. REMOVE AIR PUMP

  1. A218491
    Detach the 2 clamps from the air pump bracket.

  1. Remove the 3 insulators from the air pump.

← ON-VEHICLE INSPECTION (from Jan 2012)INSPECTION (from Jan 2012) →