REMOVAL
Removal / installation · Vehicles built from Jan 2012
| 1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Remove the 3 bolts and 2 screws.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
| 2. REMOVE FRONT FENDER APRON TRIM PACKING A |
Remove the 3 clips and front fender apron trim packing A.

| 3. DISCONNECT FRONT FENDER LINER RH |
Remove the screw, and disconnect the liner from the front bumper cover.

Using a T30 "TORX" socket, remove the 2 screws.
Remove the 4 clips.
Partially remove the fender liner.
- HINT:
- It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.
| 4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE |
Inside engine room:

Slide the clip and disconnect the No. 3 air injection system hose from the air tube.
Detach the clamp and disconnect the No. 3 air injection system hose from the clamp.
Inside front fender RH:

Detach the clamp from the air pump bracket.
Slide the clip and remove the No. 3 air injection system hose.
| 5. REMOVE AIR PUMP ASSEMBLY |
Disconnect the connector.

Detach the connector clamp from the bracket.
Disconnect the wire harness from the clamp.
Remove the 2 bolts, 2 nuts and air pump assembly.

| 6. REMOVE AIR PUMP INLET |
Remove the 2 bolts and air pump inlet.

| 7. REMOVE NO. 1 AIR INJECTION SYSTEM HOSE |
Remove the No. 1 air injection system hose from the air pump assembly.

| 8. REMOVE AIR PUMP |
Detach the 2 clamps from the air pump bracket.

Remove the 3 insulators from the air pump.
