2011-2013 Land Cruiser · Service Manual General

SERVICE DATA

Specifications · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

Starter
Specified current
90 A or less at 11.5 V
Magnet starter switch
Terminal 50 - Terminal C
Standard resistance
Below 1 Ω
Terminal 50 - Switch body
Standard resistance
Below 2 Ω
Brush
Brush length
Standard length
15.5 mm (0.610 in.)
Minimum length
8.5 mm (0.335 in.)
Starter brush holder
Brush spring
Standard spring load
18 to 24 N (1.8 to 2.4 kgf, 4.0 to 5.3 lbf)
Minimum spring load
12N (1 kgf, 2.7 lbf)
Positive (+) brush holder - Negative (-) brush holder
Standard resistance
10 Ω or higher
Starter yoke
Lead wire - Brush
Standard resistance
Below 1 Ω
Starter yoke body - Brush
Standard resistance
10 kΩ or higher
Starter armature
Segment - Segment
Standard resistance
Below 1 Ω
Segment - Coil core
Standard resistance
10 kΩ or higher
Circle runout
Maximum circle runout
0.05 mm (0.00197 in.)
Commutator
Standard diameter
30.0 mm (1.18 in.)
Minimum diameter
29.0 mm (1.14 in.)
Standard undercut depth
0.6 mm (0.0236 in.)
Minimum undercut depth
0.2 mm (0.00787 in.)
Starter relay
3 - 5
Standard resistance
10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage is applied to terminals 1 and 2)
Starter cut relay
3 - 5
Standard resistance
10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage is applied to terminals 1 and 2)
ACC relay
(Main body ECU)
2A-1 - 2D-8
Standard resistance
10 kΩ or higher (Battery voltage is not applied between 2D-45 and 2D-62)
Below 1 Ω (Battery voltage is applied between 2D-45 and 2D-62)
Engine switch
2 - 5
7 - 5
Standard resistance
Below 1 Ω (Engine switch is pushed)
10 kΩ or higher (Engine switch is not pushed)
Ignition switch
All combinations of all terminals
Standard resistance
10 kΩ or higher (LOCK)
4 (AM1) - 2 (ACC)
Standard resistance
Below 1 Ω (ACC)
4 (AM1) - 2 (ACC)
4 (AM1) - 1 (IG1)
5 (AM2) - 6 (IG2)
Standard resistance
Below 1 Ω (ON)
4 (AM1) - 1 (IG1)
4 (AM1) - 3 (ST1)
5 (AM2) - 6 (IG2)
Standard resistance
Below 1 Ω (START)
← SERVICE DATA (Sep 2011 – Dec 2011)TORQUE SPECIFICATIONS (Sep 2011 – Dec 2011) →