2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2)

  1. A271064E01
    Using SST, install the air fuel ratio sensor to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *1
    Fulcrum Length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. A239462E01
    Connect the air fuel ratio sensor connector and attach the clamp.
    Text in Illustration 
    *1
    White Tape

    HINT:
    Make sure that the white tape is in the position shown in the illustration.


2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1)

  1. A271063E01
    Using SST, install the air fuel ratio sensor to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *1
    Fulcrum Length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. Connect the air fuel ratio sensor connector and attach the clamp.


3. PERFORM AIR FUEL RATIO SENSOR COMPENSATION RESET
(Click here)
← INSPECTION (from Jan 2012)COMPONENTS (Sep 2011 – Dec 2011) →