2011-2013 Land Cruiser · Service Manual Steering

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT STEERING HEATER SWITCH

  1. C233764E06
    Disconnect the steering heater switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    HINT:
    As the circuit has a diode, perform the measurement in diode test mode, and do not mistake the polarity.

    Standard Voltage:
    Tester Connection
    (Positive (+) tester probe - Negative (-) tester probe)
    Condition
    Specified Condition
    3 (IG) - 7 (+)
    Always
    Below 1.25 V
    6 (IN) - 7 (+)
    Steering heater switch is pushed
    Below 1.25 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (IG) - 6 (IN)
    Steering heater switch is pushed
    Below 1 Ω
    3 (IG) - 6 (IN)
    Steering heater switch is not pushed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Steering Heater Switch)

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →