2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE ASSIST GRIP LH (for LH Side)

  1. B291735E01
    Using a screwdriver, detach the 2 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B291736
    Remove the 2 bolts and assist grip.


2. REMOVE DOOR INSIDE HANDLE BEZEL LH (for LH Side)

  1. B295796
    Detach the claw and open the cover.

  1. B291737
    Remove the screw.

  1. B291738E01
    Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. Detach the guide and remove the door inside handle bezel in the direction indicated by the arrow in the illustration.


3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY LH (for LH Side)

  1. B291739
    Detach the 10 clips and remove the back door trim panel.


4. REMOVE REAR ASSIST GRIP REINFORCEMENT LH (for LH Side)

  1. B291740
    Remove the 3 bolts and rear assist grip reinforcement.


5. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY LH (for LH Side)

  1. B291741
    Remove the screw.

  1. Detach the guide and remove the back door inside handle in the direction indicated by the arrow in the illustration.

  1. Disconnect the 2 links from the back door inside handle.


6. REMOVE BACK DOOR SERVICE HOLE COVER LH (for LH Side)

  1. B291742
    Disconnect the 2 connectors and detach the 3 clamps.

  1. B292850
    Pull out the 2 links and wire harness from the back door service hole cover, and then remove the back door service hole cover.

    HINT:
    Remove any remaining butyl tape from the back door panel.


7. REMOVE BACK DOOR LOCK CONTROL ASSEMBLY (for LH Side)

  1. B291743E01
    Rotate the snap in the direction indicated by the arrow in the illustration to detach the snap from the link.
    Text in Illustration 
    *1
    Snap

  1. Disconnect the link from the back door lock control.

  1. B291744
    Using a clip remover, detach the clip and remove the back door lock control.

  1. B296426
    Detach the clip from the back door panel.


8. REMOVE BACK DOOR REMOTE CONTROL ASSEMBLY (for LH Side)

  1. B291745
    Detach the guide and disconnect the cable.

  1. B291746
    Detach the clamp.

  1. Using a T30 "TORX" socket wrench, remove the bolt and back door remote control.

  1. B291747
    Detach the guide and disconnect the cable from the back door remote control.


9. REMOVE BACK DOOR LOCK ASSEMBLY (for LH Side)

  1. B291748
    Disconnect the 2 connectors.

  1. Using a T30 "TORX" socket wrench, remove the 4 bolts and back door lock.


10. REMOVE BACK DOOR OUTSIDE HANDLE (for LH Side)

  1. B291749
    Remove the 2 bolts and back door outside handle.


11. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (for LH Side)

  1. B291750E01
    Detach the clamp and disconnect the connector.

  1. Detach the grommet, and then pull out the wire harness from the back door panel.

    Text in Illustration 
    *1
    Grommet

  1. B291751
    Detach the 10 clips and remove the back door outside garnish.


12. REMOVE REAR DOOR CHILD LOCK PROTECTION COVER (for LH Side)

  1. B291752
    Remove the rear door child lock protection cover.


13. REMOVE BACK DOOR NO. 3 WEATHERSTRIP (for LH Side)

  1. B291753
    Detach the 16 clips and remove the back door No. 3 weatherstrip.


14. REMOVE BACK DOOR NO. 2 STOPPER CUSHION (for LH Side)

  1. B291754
    Remove the back door No. 2 stopper cushion.


15. REMOVE DOOR DUST PROOF SEAL LH (for LH Side)

B291755

HINT:
Use the same procedure for both door dust proof seals.

  1. Remove the door dust proof seal.


16. REMOVE BACK DOOR CHECK ASSEMBLY LH (for LH Side)
  1. Detach the clamp of the wire harness.

  1. B291756
    Remove the bolt, 2 nuts and back door check.


17. REMOVE ASSIST GRIP RH (for RH Side)

  1. B291761E01
    Using a screwdriver, detach the 2 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B291762
    Remove the 2 bolts and assist grip.


18. REMOVE BACK DOOR TRIM COVER RH (for RH Side)

  1. B291760
    Detach the 5 clips and 2 claws.

  1. B291796
    Detach the clamp and 2 claws and remove the back door trim cover.


19. REMOVE CENTER STOP LIGHT ASSEMBLY (for RH Side)
  1. Remove the center stop light assembly from the center stop light cover.

  1. Disconnect the connector.


20. REMOVE BACK DOOR TRIM PANEL ASSEMBLY RH (for RH Side)

  1. B291763
    Detach the 13 clips and remove the back door trim panel.


21. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY (w/ Rear Wiper)
  1. Open the wiper arm head cap.

  1. B283521
    Remove the nut and remove the rear wiper arm and blade assembly.


22. REMOVE REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper)

  1. B283522
    Disconnect the connector.

  1. Remove the 3 bolts and rear wiper motor assembly.


23. REMOVE REAR WIPER MOTOR GROMMET (w/ Rear Wiper)

  1. B283523
    Remove the rear wiper motor grommet.


24. REMOVE REAR WASHER NOZZLE (w/ Rear Wiper)

  1. B283561
    Disconnect the washer hose.

  1. B283529
    Detach the 2 claws and remove the rear washer nozzle.


25. REMOVE REAR ASSIST GRIP REINFORCEMENT RH (for RH Side)

  1. B291764
    Remove the 3 bolts and rear assist grip reinforcement.


26. REMOVE BACK DOOR SERVICE HOLE COVER RH (for RH Side)

  1. B291765
    Remove the back door service hole cover.

    HINT:
    Remove any remaining butyl tape from the back door panel.


27. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY RH (for RH Side)

  1. B291766
    Using a T30 "TORX" socket wrench, remove the bolt and back door inside handle.


28. REMOVE BACK DOOR HANDLE GROMMET (for RH Side)

  1. B291767
    Remove the back door handle grommet.


29. REMOVE LOWER BACK DOOR LOCK ASSEMBLY (for RH Side)

  1. B291768
    Detach the clamp and disconnect the cable.

  1. B291769
    Remove the 4 bolts, 2 screws and lower back door lock.


30. REMOVE UPPER BACK DOOR LOCK ASSEMBLY (for RH Side)

  1. B291770
    Remove the 2 bolts.

  1. Pull out the cable from the back door panel, and then remove the upper back door lock.


31. REMOVE BACK DOOR CENTER WEATHERSTRIP (for RH Side)

  1. B291773
    Detach the 5 clips and remove the back door center weatherstrip.


32. REMOVE BACK DOOR NO. 2 STOPPER SUB-ASSEMBLY (for RH Side)

  1. B291774
    Remove the 2 bolts and back door No. 2 stopper.


33. REMOVE DOOR DUST PROOF SEAL RH (for RH Side)

B291776

HINT:
Use the same procedure for both door dust proof seals.

  1. Remove the door dust proof seal.


34. REMOVE BACK DOOR LOCK STRIKER PLATE ASSEMBLY (for RH Side)

  1. B291777
    Using a T40 "TORX" socket wrench, remove the 2 bolts and back door lock striker plate.


35. REMOVE BACK DOOR CHECK ASSEMBLY RH (for RH Side)
  1. Detach the clamp of the wire harness.

  1. B291775
    Remove the bolt, 2 nuts and back door check.

← REMOVAL (from Sep 2011)ADJUSTMENT (from Sep 2011) →