2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH

  1. B302178E01
    Put protective tape around the front door outside moulding sub-assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. B302170
    Using a moulding remover, detach the 3 clamps and 11 clips, and remove the front door outside moulding sub-assembly LH.

  1. Remove any clips remaining on the door panel.

    NOTICE:
    Be careful not to allow any clips or pieces of clips to fall inside the door panel.

← COMPONENTS (from Jan 2012)INSTALLATION (from Jan 2012) →