REMOVAL
Removal / installation · Vehicles built from Jan 2012
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH |
Put protective tape around the rear door outside moulding sub-assembly LH.

Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 3 clamps and 7 clips, and remove the rear door outside moulding sub-assembly LH.

Remove any clips remaining on the door panel.
- NOTICE:
- Be careful not to allow any clips or pieces of clips to fall inside the door panel.
