Home › Vehicle Exterior › BODY PANEL › BODY LOWER BACK PANEL
BM38G0E _01 Vehicle Exterior _101965 BODY PANEL _0472904 BODY LOWER BACK PANEL F

BODY PANEL  BODY LOWER BACK PANEL  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K161940

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K161292C01
0,0 0,0 false
K108837

Adhesive - -


K161293C01
2.125,3.156 2.438,3.313 0.313,0.156 10 false *a 4.875,3.156 5.188,3.313 0.313,0.156 10 false *b
*a 112 mm (4.41 in.) *b 115 mm (4.53 in.)


K161294

K161295



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


c.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K161292C01
0,0 0,0 false
K108837

Adhesive - -


K161296C01
3.667,3.167 3.5,3.167 3.5,3.167 3.333,2.792 false 3.729,3.094 4.042,3.25 0.313,0.156 10 false *1
*1 LOWER BACK PANEL SUB-ASSEMBLY - -


K161297

K161298


d.

After welding, apply undercoating to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.