Home › Vehicle Exterior › BODY PANEL › REAR FLOOR SIDE MEMBER
BM38G0E _01 Vehicle Exterior _101965 BODY PANEL _0472907 REAR FLOOR SIDE MEMBER F

BODY PANEL  REAR FLOOR SIDE MEMBER  ASSEMBLY REPLACEMENT  


K161946

With the body lower back panel cut and join replacement sections (large areas) removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K161336C01
0,0 0,0 false
K108837

Adhesive - -


K161337

K161338



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld

a.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K161336C01
0,0 0,0 false
K108837

Adhesive - -


K161339

K161340C01
4.583,2.917 4.75,2.917 4.75,2.917 5.656,2.125 false 4.396,2.865 4.708,3.021 0.313,0.156 10 false *1
*1 REAR FLOOR SIDE MEMBER SUB-ASSEMBLY REAR - -



b.

After welding, apply undercoating to the corresponding parts. (See the painting/coating)


c.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.