Home › Vehicle Exterior › BODY PANEL › REAR FLOOR CROSSMEMBER UPPER GUSSET
BM38G0E _01 Vehicle Exterior _101965 BODY PANEL _0472922 REAR FLOOR CROSSMEMBER UPPER GUSSET F

BODY PANEL  REAR FLOOR CROSSMEMBER UPPER GUSSET  ASSEMBLY REPLACEMENT  


K161942

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K161317C01
0,0 0,0 false
K108837

Adhesive - -


K161318



INSTALLATION


Symbol Meaning
K108823

Plug Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


b.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K161317C01
0,0 0,0 false
K108837

Adhesive - -


K161319C01
3.156,1.656 2.75,1.25 2.75,1.25 2.583,1.25 false 2.396,1.188 2.708,1.344 0.313,0.156 10 false *1
*1 LOWER BACK PANEL GUSSET NO.1 - -



c.

After welding, apply the foamed sealing material to the corresponding parts. (See the painting/coating)


d.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.