SCOPE OF THE REPAIR WORK EXPLANATION
This text explains the welding panel replacement instructions from the vehicle's body in white condition. Please refer to the electronic technical manual (repair manual) for explanations of the removal and reinstallation of the equipment parts up to the body in white condition and of the installation, inspection, adjustment and final inspection of equipment parts after replacing the welding panel.
Illustrations of similar vehicle models are sometimes used. In these cases, minor details may be different from the actual vehicle.
About a symmetrical part, only one side is described.
The bold lines in the illustration indicate the standard unit for supplied parts.
When cutting and joining parts (except outer panels), do not cut and join areas or use repair procedures that are not shown in this manual.
Only work on the specified contents to maintain body strength.
When cutting and joining outer panels, cut off a necessary range depending on the damaged area, but make sure to adhere to the following precautions.
When cutting outer panels, do not cut the reinforcement or other inner panels.
When butt welding outer panels, do not allow heat to affect the reinforcement or other inner panels.
The following procedures are omitted from this manual. However, these procedures must be performed.
Use a jack or lift to perform operations.
Clean all removed parts.
Perform a visual check before and after performing any work.
SECTION CATEGORIES
This manual has been divided as shown below.
| Section Title | Contents | Examples |
|---|---|---|
| INTRODUCTION | Explanation of general body repair. Views of welded panel replacement instructions. | SYMBOLS PRECAUTIONS FOR WELDING |
| BODY PANEL | Instructions for replacing the body panels from the white body condition, from which bolted parts have been removed, with individual supply parts. | CUT AND JOIN REPLACEMENT SECTION ASSEMBLY REPLACEMENT |
| BODY DIMENSIONS | Body aligning measurements. | POINT-TO-POINT DISTANCE DISTANCE FROM CENTER LINE / DATUM PLANE |
| PAINTING / COATING | Scope and type of anti-rust treatment, etc. together with body panel replacement. | APPLICATION AREAS INSTALLATION AREAS |
TERM DEFINITIONS
| CAUTION | Possibility of injury to you or other people. |
| NOTICE | Possibility of damage to components being repaired. |
| HINT | Provides additional information to help you perform repairs. |
INTERNATIONAL SYSTEM OF UNITS
The units used in this manual comply with the International System of Units (SI UNIT) standard. Other units from the metric system and the English systems are also provided.
Example: