Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
NM38G0E _59 Vehicle Exterior _102326 LIGHTING (EXT) _0473633 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  CORNERING LIGHT CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function

*1: Models with AJA0F transmission

*2: Models with AC60F transmission

Headlight ECU Sub-assembly RH Receives cornering light control signal and illuminates the cornering light.
Headlight ECU Sub-assembly LH
·

Receives various signals and illuminates the cornering light.

·

Sends the cornering light control signal to the headlight ECU sub-assembly RH.


Turn Signal Switch Light Control Switch Sends the light control switch position signal to the steering sensor.
Turn Signal Switch Sends the turn signal switch position signal to the steering sensor.
Main Body ECU (Multiplex Network Body ECU) Sends low beam light illumination command signals to the headlight ECU sub-assembly.
Combination Meter Assembly Sends the turn signal lights control signal to the headlight ECU sub-assembly RH/LH.
Steering Sensor
·

Detects the angle of the steering wheel and sends the resulting signals to the headlight ECU sub-assembly LH.

·

Sends the light control switch position signal to the main body ECU.

·

Sends the turn signal switch position signal to the combination meter assembly.


Transmission Control ECU*1 Sends the shift position signals to the headlight ECU sub-assembly LH.
ECM*2
Brake Actuator Assembly No. 2 Skid Control ECU Sends the wheel speed signal to the headlight ECU sub-assembly LH.
Central Gateway ECU (Network Gateway ECU) Relays the signal between the CAN communication lines.


SYSTEM CONTROL


a.

Cornering Light Operating Conditions

i.

The cornering lights can illuminate when the following conditions are all met.

·

The ignition switch is on (IG).

·

Low beam headlights illuminate.

·

The vehicle speed is approximately less than 30 km/h (19 mph).




b.

Cornering Light Illumination Conditions

i.

The cornering light in the direction of travel illuminates when any of the following conditions is met.

·

Turn signal switch is turned on.

·

The steering wheel is operated approximately 80° or more to the left or right.



ii.

Both cornering lights illuminate when the following conditions is met.

·

Shift position is in R.




c.

Cornering Lights Turning Off Conditions

·

If the turn signal switch is turned off when a cornering light is illuminated by turn signal switch operation, the cornering light turns off.

·

If the steering angle is approximately 30° or less when a cornering light is illuminated by steering operation, the cornering light turns off.

·

If the shift position is changed to a position other than R when the cornering lights are illuminated with the shift position in R, the cornering lights turn off.




FAIL-SAFE


a.

When a system malfunction is detected, the headlight ECU sub-assembly LH enters fail-safe mode. For details, refer to the Repair Manual.



DIAGNOSTIC


a.

In order to make system inspections easier to perform, a diagnosis function is used in consideration of serviceability. The Diagnostic Trouble Codes (DTCs) of malfunctions can be read by connecting the Global TechStream (GTS). For details, refer to the Repair Manual.