FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
|
*: Models with front differential lock mechanism |
||
| Front Differential Actuator Assembly* | No.1 Front Differential Case Sub-Assembly | Switches the front differential between free mode and lock mode in accordance with signals from the 4 wheel drive control ECU. |
| No. 1 4 Wheel Drive Position Switch | Detects the front differential position (free mode or lock mode). | |
| Rear Differential Actuator Assembly | Electronic Differential Lock Case Sub-assembly | Switches the rear differential between free mode and lock mode in accordance with signals from the 4 wheel drive control ECU. |
| Differential Lock Indicator Switch | Detects the rear differential position (free mode or lock mode). | |
| Front Differential Lock Switch* | Selects the front differential position (free mode or lock mode). | |
| Rear Differential Lock Switch | Selects the rear differential position (free mode or lock mode). | |
| 4 Wheel Drive Control ECU | Controls the coil assembly in the electronic differential lock case sub-assembly and No.1 front differential case sub-assembly* based on the signals from each switch and the vehicle speed signal from the skid control ECU. | |
| Combination Meter Assembly | Front Differential Lock Indicator* | Illuminates or flashes to inform the driver of the front differential lock system condition. |
| Rear Differential Lock Indicator | Illuminates or flashes to inform the driver of the rear differential lock system condition. | |
| ABS Warning Indicator | Turn on in accordance with the front differential lock system* or rear differential lock system mode when ABS function is not operating. | |
| Multi-information Display | Display a message in accordance with the front differential lock system* or rear differential lock system mode when TRC function is not operating. | |
| Buzzer | Sounds when the switching conditions are not met while switching the front differential lock system or rear differential lock system mode. | |
SYSTEM CONTROL
When all of the following conditions are met, the front differential lock* or rear differential lock operates.
*: Models with front differential lock mechanism
|
*: Models with front differential lock mechanism |
|
·
The drive mode is in L4L (low range 4WD and center differential locked).
·
The vehicle speed is 8 km/h (5 mph) or lower.
·
The front differential lock switch* or rear differential lock switch is pushed. |
The front differential* or rear differential should not be switched from free mode to lock mode while the vehicle is turning or while the wheels are spinning.
*: Models with front differential lock mechanism
The 4 wheel drive control ECU uses the buzzer, front differential lock indicator* and rear differential lock indicator in the combination meter assembly to display the condition of the front differential lock system* and rear differential lock system.
*: Models with front differential lock mechanism
| Condition | Front Differential Lock Indicator* or Rear Differential Lock Indicator | Buzzer |
|---|---|---|
|
*: Models with front differential lock mechanism |
||
| Differential lock currently switching (between Free mode and Lock mode) | Flashes slowly | OFF |
| Differential lock switching complete (Lock mode) | Turns on | OFF |
| Differential lock system malfunction | Flashes fast | OFF |
| Differential Free/Lock switching condition violation | Flashes 3 times | Sounds 3 times |
DIAGNOSIS
When the 4 wheel drive control ECU detects a malfunction, the 4 wheel drive control ECU records the malfunction and memorizes the information related to the fault. Furthermore, the 4 wheel drive control ECU flashes the front differential lock indicator* or rear differential lock indicator in the combination meter to inform the driver.
The 4 wheel drive control ECU will also store the Diagnostic Trouble Codes (DTCs) of the malfunctions. The DTCs stored in the 4 wheel drive control ECU are output to the Global TechStream (GTS) via the DLC3.
For details, refer to the Repair Manual.