FUNCTION
When abnormal driver accelerator pedal and shift operations are detected, the system restricts the engine output and informs the driver.
When the VSC OFF switch is operated to turn the TRC OFF mode, the system does not operate.
When 4WD is L4 position by 4WD switch, the drive start control does not operate.
When Center Differential Lock Mechanism is locked by Center Differential Lock switch, the drive start control does not operate.
When the system is operating, even if the driver depresses and holds the accelerator pedal, engine output may increase on an uphill slope and decrease on a downhill slope. This behavior allows the system to restrict the vehicle speed and acceleration below the predetermined limit on slopes and is not a malfunction.
Control During Shift Operation
Responds to shift operations with the accelerator pedal depressed.
Changes the limit amount according to the shift operation pattern.
Corrects engine output according to the road grade.
Control when Starting Off from a Parked Position
|
*: Operation may not be possible in certain situations. |
|
| Control Start Conditions (When all of the following conditions are met, control starts.) |
·
Accelerator opening angle is approximately 1/5 or higher.
·
Shift position is changed from P to D/S, or P to R.* |
| Control Operation | Restricts the engine output so the vehicle speed and acceleration are at or below a certain level. |
| Control Stop Conditions |
·
Accelerator pedal is fully released.
·
Shift position is P or N. |
Control during Other Situations
| Control Start Conditions (When all of the following conditions are met, control starts.) |
·
Accelerator opening angle is approximately 1/5 or higher.
·
Shift position is changed from R to D/S, D/S to R, or N to R. |
| Control Operation | Restricts the engine output so the vehicle speed and acceleration are at or below a certain level. |
| Control Stop Conditions |
·
Accelerator pedal is fully released.
·
Shift position is P or N. |
The engine output restraint level differs in the above 2 situations.
During control while a shift operation is performed (from control start until the accelerator pedal is released), the system informs the driver of the control via the combination meter assembly.
Control during Reverse Operation
Responds to excessive depression of the accelerator pedal while operating in reverse.
Corrects engine output according to the road grade.
| Control Start Conditions (When all of the following conditions are met, control starts.) |
·
Shift position is R.
·
Accelerator pedal is depressed excessively. |
| Control Operation | Restricts the engine output so the vehicle speed and acceleration are at or below a certain level. |
| Control Stop Conditions |
·
Shift position is not R.
·
Accelerator pedal is fully released. |