CONSTRUCTION
The cylinder head sub-assembly structure has been simplified by separating the camshaft housing (cam journal portion) from the cylinder head.
The cylinder head, which is made of aluminum, contains a pentroof-type combustion chamber. The spark plug has been located in the center of the combustion chamber in order to improve the engine's anti-knocking performance.
The intake ports are on the inside and the exhaust ports on the outside of the left and right banks respectively.
Upright intake ports are used to improve the intake efficiency.
A taper squish combustion chamber is used to improve anti-knocking performance and intake efficiency. In addition, engine performance and fuel economy have been improved.
By fitting the fuel injector assembly so that its nozzle end juts into the intake port, the intake port cross sectional area has become smooth, enhancing the efficiency of air intake. Furthermore, the distance between the injector nozzle end and intake valve has been shortened. As a result, the amount of fuel that adheres to the intake port has been reduced, increasing the fuel economy as well as reducing the exhaust emissions.
The siamese type intake port is used to reduce the overall surface area of the intake port walls. This prevents the fuel from adhering onto the intake port walls, thus reducing HC exhaust emissions.
| *1 | Intake Valve | *2 | Spark Plug Hole |
| *3 | Exhaust Valve | *4 | Camshaft Housing |
| *5 | Cylinder Head | - | - |
| *a | Bottom Side View | *b | A - A Cross Section |
| *c | Intake Side | *d | Exhaust Side |
Siamese Type Intake Port and Independent Type Intake Port
| *A | Siamese Type | *B | Independent Type |
The cylinder head bolts have been positioned below the camshaft journal in the front of the right bank, and the holes for placing the bolts have been provided above the camshaft journal. Thus, the front end of the right bank has been shortened, resulting in a shorter overall length of the engine.
| *1 | Cylinder Head Bolt | *2 | Camshaft Journal |
| *a | Right Bank Cylinder Head | *b | Front |
| *c | Shortened | - | - |