Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › SFI SYSTEM
NM38G0E _51 Engine / Hybrid System _101627 V35A-FTS ENGINE CONTROL _0478156 SFI SYSTEM CO CONTROL F

V35A-FTS ENGINE CONTROL  SFI SYSTEM  CONTROL  ELECTRICAL SPARK ADVANCE (ESA) CONTROL  


FUNCTION


a.

The Direct Ignition System (DIS) is used. Each ignition coil assembly is equipped with a built-in igniter, and one ignition coil assembly is provided for each cylinder. The ECM performs ignition timing control in accordance with the engine status based on the signal from the sensors.

W139149E02
0.281,0.25 3.167,0.479 2.885,0.229 10 false Mass Air Flow Meter Sub-assembly x 2 0.698,0.823 2.625,1.073 1.927,0.25 10 false Intake Air Temperature Sensor 4.219,2.719 4.604,2.938 0.385,0.219 10 false ECM 0.958,1.479 2.396,1.708 1.438,0.229 10 false Crank Position Sensor 0.688,2 2.792,2.198 2.104,0.198 10 false Cam Position Sensor (Intake) x 2 0.604,2.5 2.823,2.708 2.219,0.208 10 false Cam Position Sensor (Exhaust) x 2 0.865,3.698 2.417,3.917 1.552,0.219 10 false Throttle Position Sensor 0.604,3.125 2.833,3.354 2.229,0.229 10 false Throttle Body with Motor Assembly 0.49,4.552 2.958,4.792 2.469,0.24 10 false Engine Coolant Temperature Sensor 0.844,5.094 2.51,5.333 1.667,0.24 10 false Knock Control Sensor x 2 0.802,6.458 2.604,6.677 1.802,0.219 10 false : CAN Communication Line 1.052,5.75 2.271,6 1.219,0.25 10 false Shift Control ECU 5.521,3 6.885,3.479 1.365,0.479 10 false Ignition Coil Assembly x 6


b.

The ECM calculates the most appropriate ignition timing and the time that current is applied to the primary windings of the ignition coil based on the signals sent from various sensors. The ECM then sends an ignition command signal to the igniter of the ignition coil assembly.


c.

The ignition timing is obtained using the following formula:

Ignition timing = A or B + C

Where: A: Base ignition timing, B: Basic advance, C: Compensation advance

Ignition Timing Controls
A. Fixed advance characteristics The base ignition timing is 5° BTDC. It is fixed at 5° BTDC while the engine is starting (fixed at 10° ATDC when the engine coolant temperature is high). In addition, the base ignition timing is fixed at 10° BTDC when the service terminals are connected and the throttle motor is off.
B. Basic advance characteristics The most appropriate ignition timing is selected from a map based on the signals from a variety of sensors.
C. Compensation advance characteristics The ignition timing is advanced or retarded depending on the signals from a variety of sensors.
C-1. Warm engine advance characteristics When the engine coolant temperature is low, the ignition timing is advanced in accordance with driving conditions to enhance drivability.
C-2. Idle stabilization advance characteristics If the idle speed drops, the ignition timing is advanced to stabilize the idle speed. If the idle speed increases, the ignition timing is retarded.
C-3. Knock compensation retard If knock occurs, the ignition timing is corrected based on the signal from the knock control sensor.