CONSTRUCTION
An accessory belt system using 2 belts is used. The design takes friction loss, belt tension and the balance of the belt weight on engine accessories into consideration.
A friction-type belt tensioner is used. Friction loss is reduced and fuel economy is improved.
Waterproof and dust-proof ball bearings are used in the bearings of the idler pulley and belt tensioner in order to improve reliability in various environments.
| *1 | Water Pump Pulley | *2 | No.1 Fan Belt |
| *3 | Generator with Clutch Pulley | *4 | No.1 V-ribbed Belt Tensioner Assembly |
| *5 | Crankshaft Pulley | *6 | Air Conditioning Compressor Pulley (Compressor with Pulley Assembly) |
| *7 | Idler Pulley Sub-assembly | *8 | No.2 Fan Belt |
| *9 | Shaft with Pulley Sub-assembly | *10 | No.2 V-ribbed Belt Tensioner Assembly |
| *11 | Arm | *12 | Idler Pulley |
| *13 | Pulley Bolt | *14 | Ball Bearing |
| *15 | Shaft | *16 | Spring |
| *a | No.2 V-ribbed Belt Tensioner Assembly Cross Section | *b | No.1 V-ribbed Belt Tensioner Assembly Cross Section |
| *c | Idler Pulley Sub-assembly Cross Section | - | - |