CONSTRUCTION
An absorber control actuator that switches the damping force is positioned inside the front shock absorber assembly.
| *1 | Front Shock Absorber Assembly | - | - |
The rear shock absorber assembly has an absorber control actuator, which changes the damping force, positioned on the lower part of the outer shell.
A center pipe is provided to create an oil passage to the absorber control actuator. During bound and rebound, oil flows in the same direction in the center pipe and the damping force is changed within the absorber control actuator.
| *1 | Rear Shock Absorber Assembly | *2 | Absorber Control Actuator |
| *1 | Piston Valve | *2 | Base Valve |
| *3 | Absorber Control Actuator | *4 | Center Pipe |
| *a | During Bound | *b | During Rebound |
OPERATION
Pilot pressure at the rear of the main valve is controlled to vary the pressure (damping force) that opens the main valve. The pilot pressure is continuously adjusted by the linear solenoid to achieve superior response.
The pilot pressure is determined by the balance between the linear solenoid action and piston pressure. When the linear solenoid action is small (low current), the pilot pressure becomes lower. As a result, the damping force becomes lower. Conversely, when the linear solenoid action is large (high current), the pilot pressure becomes higher. As a result, the damping force becomes higher.
| *1 | Linear Solenoid | *2 | Main Valve |
| *a | During Bound | *b | During Rebound |
| *c | Pilot Pressure Chamber | *d | Piston Pressure Chamber |
| *e | Pilot Valve | - | - |
|
Piston Pressure |
|
Pilot Pressure |
| *1 | Main Valve | *2 | Pilot Valve |
| *3 | Linear Solenoid | - | - |
| *a | Pilot Pressure Chamber | *b | Piston Pressure Chamber |
|
Piston Pressure |
|
Pilot Pressure |