Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM38G0E _54 Brake _102389 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0479577 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  EMERGENCY BRAKE SIGNAL  


SYSTEM CONTROL


a.

The emergency brake signal system reduces the danger of rear-end collisions by automatically flashing the hazard warning lights during emergency braking to warn vehicles to the rear.

X135590


b.

When the No. 2 skid control ECU detects emergency braking operations according to each sensor and the operation condition of the brake pedal, it sends emergency brake signal operation request signals to the combination meter assembly. As a result, the combination meter assembly flashes the turn signal lights.


c.

When the hazard warning lights are flashed, the emergency brake signal stops operating.

X149888E05
3.042,0.167 4.021,0.635 0.979,0.469 10 false Brake Actuator Assembly 0.396,0.906 1.958,1.375 1.563,0.469 10 false Airbag ECU (Airbag ECU Assembly) 0.208,3.094 2.167,3.677 1.958,0.583 10 false Central Gateway ECU (Network Gateway ECU) 0.229,4.365 2.146,4.688 1.917,0.323 10 false Combination Meter Assembly 0.25,5.094 2.135,5.49 1.885,0.396 10 false Hazard Warning Signal Switch Assembly 3.208,4.354 4.573,4.688 1.365,0.333 10 false Turn Signal Lights 3.156,1.708 3.833,2.656 0.677,0.948 10 false No. 2 Skid Control ECU 5.656,1.625 7.021,1.958 1.365,0.333 10 false Speed Sensor 5.219,2.823 7.135,3.156 1.917,0.333 10 false Stop Light Switch Assembly 5.219,5.354 7,5.646 1.781,0.292 10 false : CAN communication line 2.24,4.729 4.01,4.958 1.771,0.229 10 false Turn Signal Light Flash 4.354,3.219 6.521,3.458 2.167,0.24 10 false Brake Pedal Depressing Signal 4.354,2.01 6,2.344 1.646,0.333 10 false Wheel Speed Signal

i.

Operation conditions of the emergency brake signal

·

Emergency brake signal operates when all of the following conditions have been met:

Emergency Brake Signal Operation Conditions
·

The vehicle speed is approximately 55 km/h or more.

·

The brake pedal is depressed and the vehicle is judged to be rapidly braking based on the deceleration rate.





ii.

Cancellation conditions of the emergency brake signal

·

If any one of the following conditions is met during emergency brake signal operation, emergency brake signal will be canceled.

Emergency Brake Signal Cancellation Conditions
·

When the hazard warning lights are turned on by operating the hazard warning signal switch.

·

The brake pedal is released.

·

The parking brake is applied.

·

The deceleration rate of the vehicle is judged not to be high. The vehicle is judged not to be rapidly braking based on the deceleration rate.