CONSTRUCTION
Anti-corrosion Sheet Steel
Anti-corrosion sheet steel is used as in the following illustration:
| *a | Anti-corrosion Sheet Steel | - | - |
| *a | Anti-corrosion Sheet Steel | - | - |
Anti-chipping Application and Rust-resistant Performance
Wax is applied to the floor panel and edge of the door lower portion, door hinge, fuel filler lid hinge, and the hemmed portions of the hood panel and back door panel to improve rust-resistant performance.
| *1 | Hood Hinge Assembly LH | *2 | Hood Hinge Assembly RH |
| *3 | Hood Sub-assembly | *4 | Front Door Hinge Assembly Upper LH |
| *5 | Front Door Hinge Assembly Lower LH | *6 | Fuel Filler Opening Lid Assembly |
| *7 | Rear Door Hinge Assembly Lower LH | *8 | Rear Door Hinge Assembly Upper LH |
| *9 | Back Door Hinge Assembly | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | Wax | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | Wax | - | - |
Polyvinyl Chloride (PVC) coating is applied to the wheel housings, and other parts that are located where they are susceptible to stone chipping damage, improving the rust-resistance of these areas.
| *a | Edge Seal | *b | Under Coating Area (Wet Condition Min. Thickness: 1.5 mm) |
| *c | Under Coating Area (Wet Condition Min. Thickness: 1.0 mm) | - | - |