Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM
NM38G0E _58 Vehicle Interior _102330 THEFT DETERRENT / KEYLESS ENTRY _0481981 ENTRY AND START SYSTEM DE DETAILS F

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM  DETAILS  ENGINE SWITCH  


CONSTRUCTION


a.

The power switch consists of a momentary type switch, illumination and antenna coil.


b.

A fingerprint sensor that reads fingerprint information is provided at the center of the engine switch. *


c.

The engine switch with fingerprint authentication system is a precision instrument. Be careful of the following items.*

·

Do not subject to strong impact, or remove, disassemble or modify the main body. This could result in failure or malfunction.

·

Do not poke or scratch the surface of the fingerprint sensor with a pen or other sharp object. This could damage the surface of the fingerprint sensor.

·

Dirt may accumulate after use for a long time. Even in this case, do not remove the dirt with a pointed object.

·

Do not attach a sticker to the surface of the fingerprint sensor or color it with ink.

·

Clean the surface of the fingerprint sensor occasionally. Dust, skin grease, sweat or other dirt attached to the surface of the fingerprint sensor, or condensation that occurs, could cause a malfunction.


*: Models with fingerprint authentication system


Models without Fingerprint Authentication System
Y226210

Models with Fingerprint Authentication System
Y275288C01
3.625,0.885 4.677,1.063 true 4.74,0.99 5.052,1.188 0.313,0.198 10 false *a
*a Fingerprint Sensor - -




OPERATING CONDITION


a.

Fingerprint sensor (Models with fingerprint authentication system)

i.

When any of the following operation conditions is met while the power source is off, the authentication of the fingerprint sensor becomes available.

·

When the driver door is opened or closed

·

When the engine switch is pressed or the brake pedal is operated after a fingerprint sensor start prohibition

·

When fingerprint authentication is performed by a registered user when changing to fingerprint registration mode

·

When a fingerprint is registered



ii.

When any of the following operation conditions is met, the authentication of the fingerprint sensor is prohibited.

·

When the fingerprint authentication result is a match or the electrical key is held over the engine switch (transponder certification result is OK)

·

When the vehicle speed is detected