CONSTRUCTION
The No. 1 clearance warning buzzer is installed in the instrument panel. The sound pattern of the buzzer changes when a static object is detected in front of the vehicle to notify the driver of the approximate distance of the object from the vehicle.
The No. 2 clearance warning buzzer is installed on the rear inside the vehicle. The sound pattern of the buzzer changes when a static object is detected behind the vehicle to notify the driver of the approximate distance of the object from the vehicle.
Sounding of the No. 1 clearance warning buzzer and No. 2 clearance warning buzzer is controlled by the clearance warning ECU assembly.
| Item | Specification | |
|---|---|---|
| No. 1 Clearance Warning Buzzer | Operation Frequency [kHz] | 2.4 +/- 0.04 |
| Sound Pressure Level [dB]* | 80 +/- 6 | |
| No. 2 Clearance Warning Buzzer | Operation Frequency [kHz] | 2.0 +/- 0.04 |
| Sound Pressure Level [dB]* | 91 +/- 6 | |
*: This is the sound pressure level at a position 1 m (3.28 ft.) away from the buzzer itself, not the level where the driver would be sitting (where the sound would actually be heard).
OPERATION
Clearance Warning Buzzer Sounding
If a static object is detected at longest range, long-range or medium-range, the buzzer sounding interval changes approximately every 100 mm (3.94 in.) according to the distance from the object, and the clearance warning buzzer sounds.
If a static object is detected at short-range or shortest range, the clearance warning buzzer sounds continuously.
If both a front sensor and rear sensor detect an object at the same time, both the No. 1 and No. 2 clearance warning buzzers sound independently (based on the front detection distance for No. 1 and the rear detection distance for No. 2).