CONSTRUCTION
The multi-layer plastic fuel tank assembly consists of 6 layers of 4 types of materials, and one of those is a recyclable material to address environmental concerns.
A jet pump, which automatically transfers fuel from the fuel sub tank assembly to the fuel tank assembly, is provided in the fuel tank assembly on models with a dual fuel tank.
A fuel drain mark has been provided at the lowest position of the fuel tank assembly. When dismantling (scrapping) the vehicle, drain fuel by drilling a hole at the drain mark.
| *1 | Fuel Tank Assembly | - | - |
| *a | Fuel Tank Assembly Outside | *b | Fuel Tank Assembly Inside |
| *c | Fuel Tank Assembly Wall Cross Section | *d | High Density Polyethylene (HDPE) |
| *e | Regrind Material | *f | Adhesive |
| *g | Ethylene Vinyl Alcohol Copolymer (EVOH) | *h | Fuel Drain Mark |
| *i | View from Bottom Side | *j | HDPE : Lightweight and strong, this also provides superior resistance to water and solvents. |
| *1 | Fuel Sub Tank Assembly | - | - |
| *a | Fuel Sub Tank Assembly Outside | *b | Fuel Sub Tank Assembly Inside |
| *c | Fuel Sub Tank Assembly Wall Cross Section | *d | High Density Polyethylene (HDPE) |
| *e | Regrind Material | *f | Adhesive |
| *g | Ethylene Vinyl Alcohol Copolymer (EVOH) | *h | Fuel Drain Mark |
| *i | View from Bottom Side | *j | HDPE : Lightweight and strong, this also provides superior resistance to water and solvents. |