Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM38G0E _59 Vehicle Exterior _100456 WIPER / WASHER _0467212 WASHER LEVEL WARNING SWITCH G

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT LEVEL WARNING SWITCH

a.

Measure resistance

i.

Add washer fluid to the washer jar with the level warning switch assembly installed to the washer jar.


ii.
E158668C29
1.438,0.125 1.885,0.354 0.448,0.229 2.031,1.292 2.656,1.292 true 0.677,1.302 1.385,1.302 true 0.115,0.396 0.427,0.594 0.313,0.198 10 false *a 2.74,1.229 3.052,1.427 0.313,0.198 10 false S 0.552,1.24 0.865,1.438 0.313,0.198 10 false E 1.531,0.167 1.844,0.365 0.313,0.198 10 false B51
*a Component without harness connected
(Level Warning Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B51)Location & Routing

Click Connector(B51)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>Level Warning Switch Assembly

B51-1 (S) - B51-2 (E) Fluid volume is 600 to 800 cc (36.7 to 48.8 cu. in.) or more* 10 kΩ or higher
B51-1 (S) - B51-2 (E) Fluid volume is 600 to 800 cc (36.7 to 48.8 cu. in.) or less* Below 1 Ω


HINT:
·

Perform checks by reducing the amount of washer fluid.

·

*: The level warning switch assembly activates when the washer fluid is 600 to 800 cc or less according to the vehicle condition (vehicle stability etc.)