Home › Vehicle Exterior › WIPER / WASHER › RELAY
RM38G0E _59 Vehicle Exterior _100456 WIPER / WASHER _0467219 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85941 1.INSPECT WINDSHIELD WASHER RELAY

a.
E367719C05
1.146,0.948 1.313,0.49 false 1.281,1.771 1.125,1.333 false 0.802,0.99 0.969,0.531 false 0.719,1.719 0.563,1.281 false 1.323,0.302 1.635,0.5 0.313,0.198 10 false 1 1.292,1.771 1.604,1.969 0.313,0.198 10 false 2 0.969,0.344 1.281,0.542 0.313,0.198 10 false 5 0.719,1.74 1.031,1.938 0.313,0.198 10 false 3 0.073,0.073 0.385,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(WIPER Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the WIPER relay.


Hide 87299C 2.INSPECT WASHER NOZZLE HEATER RELAY (w/ Heater)

a.
E367719C05
1.146,0.948 1.313,0.49 false 1.281,1.771 1.125,1.333 false 0.802,0.99 0.969,0.531 false 0.719,1.719 0.563,1.281 false 1.323,0.302 1.635,0.5 0.313,0.198 10 false 1 1.292,1.771 1.604,1.969 0.313,0.198 10 false 2 0.969,0.344 1.281,0.542 0.313,0.198 10 false 5 0.719,1.74 1.031,1.938 0.313,0.198 10 false 3 0.073,0.073 0.385,0.229 0.313,0.156 10 false *a
*a Component without harness connected
(Nozzle Heater Relay)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the nozzle heater relay.