Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM38G0E _54 Brake _100464 BRAKE SYSTEM (OTHER) _0467264 BRAKE FLUID G

BRAKE SYSTEM (OTHER)  BRAKE FLUID  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.


HINT:

If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. After repair or replacement, adjust the brake fluid level in the reservoir as specified below.


PROCEDURE

Hide 51474B 1.DISCONNECT ENGINE SIDE COVER LH (except 1GR-FE (for LHD))

a.
C455263

Disengage the 2 claws.


b.
C455265C01
0,0 0,0 false
V113147

Pull up in this Direction


Pull up the engine side cover LH as shown in the illustration.


c.

Engage the claw of cowl top ventilator louver sub-assembly into the groove of engine side cover LH to fix engine side cover LH.


Hide 51473C 2.DISCONNECT ENGINE SIDE COVER RH (for RHD)

a.
C455264

Disengage the 2 claws.


b.
C455266C01
0,0 0,0 false
V113147

Pull up in this Direction


Pull up the engine side cover RH as shown in the illustration.


c.

Engage the claw of cowl top ventilator louver sub-assembly into the groove of engine side cover RH to fix engine side cover RH.


Hide 3.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (When Using the GTS)

a.

Select "Zero Down" on the "ECB Utility" screen.

Chassis > Brake/EPB > Utility
Tester Display
ECB Utility
50005 435 3617

b.

Enter "Next" and wait for 10 seconds.


c.
C452207C02
0.729,0.938 1.229,0.938 1.229,0.938 1.51,1.177 true 1.542,1.448 1.719,1.688 1.719,1.688 2.302,1.688 true 1.792,3.771 1.885,3.583 1.885,3.583 2.469,3.583 true 1.156,4.26 1.656,4.26 1.656,4.26 1.75,4.083 true 0,0 0.26,0.188 0.26,0.188 12 true *A 0,2.5 0.26,2.677 0.26,0.177 12 true *B 0.521,0.823 0.74,1.01 0.219,0.188 10 true *a 2.323,1.594 2.51,1.771 0.188,0.177 10 true *b 2.531,3.49 2.75,3.677 0.219,0.188 10 true *a 0.938,4.156 1.125,4.333 0.188,0.177 10 true *b
*A for LHD
*B for RHD
*a MAX Line
*b MIN Line


After the booster pump has stopped, check that the brake fluid level is between the MAX and MIN lines. If necessary, add brake fluid to the reservoir until the brake fluid level is at the MAX line.

Brake Fluid:

SAE J1703 or FMVSS No. 116 DOT3

SAE J1704 or FMVSS No. 116 DOT4


HINT:
C458910C01
0,0 0,0 false
V113147

Remove in this Direction


except 1GR-FE:

Remove the engine side cover LH to add brake fluid.



Hide 4.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (When Not Using the GTS)

a.
C452207C04
0.875,1.375 1.375,1.375 1.375,1.375 1.49,1.26 true 1.542,1.448 1.719,1.688 1.719,1.688 2.302,1.688 true 1.156,4.26 1.656,4.26 1.656,4.26 1.75,4.083 true 1.823,3.865 1.938,3.99 1.938,3.99 2.521,3.99 true 0,0 0.26,0.188 0.26,0.188 12 true *A 0,2.49 0.26,2.667 0.26,0.177 12 true *B 0.615,1.25 0.833,1.438 0.219,0.188 10 true *a 2.323,1.594 2.51,1.771 0.188,0.177 10 true *b 2.531,3.875 2.75,4.063 0.219,0.188 10 true *a 0.938,4.156 1.125,4.333 0.188,0.177 10 true *b
*A for LHD
*B for RHD
*a Fluid Level Support Line
*b MIN Line


Check that the fluid level is above the MIN line with the ignition switch ON. Adjust the brake fluid level of the reservoir so that it is between the MIN line and fluid level support line.

Brake Fluid:

SAE J1703 or FMVSS No. 116 DOT3

SAE J1704 or FMVSS No. 116 DOT4


HINT:
C458910C01
0,0 0,0 false
V113147

Remove in this Direction


except 1GR-FE:

Remove the engine side cover LH to add brake fluid.