1.INSPECT OIL PUMP ASSEMBLY CLEARANCE
Push the front oil pump driven gear to one side of the front oil pump body.
Using a feeler gauge, measure the clearance between the front oil pump driven gear and front oil pump body.
0.135 to 0.185 mm (0.00532 to 0.00728 in.)
If the clearance is not as specified, replace the front oil pump drive gear, front oil pump driven gear and front oil pump body.
Using a feeler gauge, measure the clearance between the front oil pump driven gear teeth and front oil pump drive gear teeth.
0.02 to 0.10 mm (0.000788 to 0.00393 in.)
If the tip clearance is not as specified, replace the front oil pump drive gear, front oil pump driven gear and front oil pump body.
Using a straightedge and feeler gauge, measure the side clearance of both gears.
0.017 to 0.030 mm (0.000670 to 0.00118 in.)
If the side clearance is not as specified, replace the front oil pump drive gear, front oil pump driven gear and front oil pump body.
There are 3 front oil pump drive gears and 3 front oil pump driven gears of different thicknesses.
| Part No. | Thickness |
|---|---|
| 35321-60210 | 13.635 to 13.640 mm (0.53682 to 0.53700 in.) |
| 35321-60220 | 13.638 to 13.643 mm (0.53693 to 0.53712 in.) |
| 35321-60230 | 13.641 to 13.646 mm (0.53705 to 0.53724 in.) |
| Part No. | Thickness |
|---|---|
| 35322-60210 | 13.635 to 13.640 mm (0.53682 to 0.53700 in.) |
| 35322-60220 | 13.638 to 13.643 mm (0.53693 to 0.53712 in.) |
| 35322-60230 | 13.641 to 13.646 mm (0.53705 to 0.53724 in.) |
35783 2.INSPECT DRIVEN SPROCKET
Check the driven sprocket for wear or damage.
If any of the following defects is found, replace the driven sprocket.
3.INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION
|
Rotates Smoothly |
Install the driven sprocket to the front oil pump assembly.
Check that the front oil pump drive gear rotates smoothly.
Remove the driven sprocket from the front oil pump assembly.