Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › ACCELERATOR PEDAL
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467366 ACCELERATOR PEDAL G

V35A-FTS ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL(WITH SENSOR) ROD ASSEMBLY

a.

Warm up the engine.


b.

Turn the A/C switch off.


c.

According to the display on the GTS, read the Data List.

Powertrain > Engine > Data List
Tester Display
Accelerator Position Sensor No.1 Voltage
Accelerator Position Sensor No.2 Voltage
50003 372 87,88

d.

Read the values displayed on the GTS.

Standard Voltage:
Tester Display Condition Specified Condition
Accelerator Position Sensor No.1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
Accelerator pedal fully depressed 2.6 to 4.5 V
Accelerator Position Sensor No.2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
Accelerator pedal fully depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal(with sensor) rod assembly, wire harness and ECM.