22204 1.INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
Perform "Inspection After Repair" after replacing the intake mass air flow meter sub-assembly.
Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Read the value of Data List item "MAF Sensor" using the GTS.
Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner assembly (installed to the vehicle).
Check and ensure the following conditions:
Turn off all electrical loads, such as the air conditioning, etc.
Check that the coolant temperature is 75°C (167°F) or more.
Put the shift lever in the N position.
Start the engine.
According to the display on the GTS, read the Data List when the engine is running.
| Tester Display |
|---|
| MAF Sensor Bank1 |
| MAF Sensor Bank2 |
| GTS Display | Condition | Specified Condition |
|---|---|---|
| MAF Sensor Bank 1 MAF Sensor Bank 2 |
Idling (engine warmed up) | 1.8 to 3.0 gm/sec |
| 2000 rpm (without load) | 5.0 to 25.0 gm/sec | |
| 3000 rpm (without load) | 6.5 to 30.0 gm/sec |
If the result is not as specified, clean (air blow) the intake mass air flow meter sub-assembly.
After cleaning (air blowing) the intake mass air flow meter sub-assembly, perform an on-vehicle inspection of the intake mass air flow meter sub-assembly again and replace the intake mass air flow meter sub-assembly if the result is not as specified.
If the result is within the specified range, inspect the mass air flow meter sub-assembly.
Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION
22204 2.CLEAN INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
If the mass air flow meter sub-assembly is removed and installed 10 times or more, the thread of the hole of the mass air flow meter sub-assembly may be damaged. Therefore, do not loosen the screws of the mass air flow meter sub-assembly.
Remove the air cleaner cap sub-assembly.
| *1 | Mass Air Flow Meter Sub-assembly |
| *a | Air Blow Gun |
| *b | 10 mm (0.394 in.) |
| *c | Airflow Hole |
Clean the mass air flow meter sub-assembly.
Do not contact the mass air flow meter sub-assembly with the nozzle of the air blow gun.
Do not insert the nozzle of the air blow gun into the airflow hole.
| *a | Air Blow Duration |
| *b | 3 to 6 Seconds |
| *c | 1 Second |
| *d | Air Blowing |
| *e | Air Stopped |
Using an air blow gun, clean the hole of the mass air flow meter sub-assembly by applying approximately 10 intermittent bursts of air to the airflow hole at a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm2, 57 to 142 psi).
Install the air cleaner cap sub-assembly.