Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467371 ENGINE COOLANT TEMPERATURE SENSOR G

V35A-FTS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT E.F.I. ENGINE COOLANT TEMPERATURE SENSOR

CAUTION:
A342307

·

Do not put your hands into the water that has been heated for the inspection.

·

Touching the heated water could result in burns.



a.
A402373C11
1.542,0.031 1.875,0.25 0.333,0.219 1.073,0.75 1.552,0.75 true 1.865,0.76 2.344,0.76 true 0.094,0.052 0.49,0.292 0.396,0.24 10 false *a 1.594,0.083 1.969,0.365 0.375,0.281 10 false C28 2.406,0.667 2.781,0.948 0.375,0.281 10 false E2 0.708,0.667 1.083,0.948 0.375,0.281 10 false THW
*a Component without harness connected
(E.F.I. Engine Coolant Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C28)Location & Routing

Click Connector(C28)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>E.F.I. Engine Coolant Temperature Sensor

C28-1 (E2) - C28-2 (THW) 20°C (68°F) 2.31 to 2.58 kΩ
80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

If checking the E.F.I. engine coolant temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the E.F.I. engine coolant temperature sensor.


If the result is not as specified, replace the E.F.I. engine coolant temperature sensor.