Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › VACUUM SENSOR
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467374 VACUUM SENSOR G

V35A-FTS ENGINE CONTROL  VACUUM SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421K 1.INSPECT NO. 1 TURBO PRESSURE SENSOR

a.

Warm up the engine.


b.

Turn the A/C switch off.


c.

According to the display on the GTS, read the Data List.

Powertrain > Engine > Data List
Tester Display
Turbocharger/Supercharger Inlet Pressure Bank1
Turbocharger/Supercharger Inlet Pressure Bank2
50003 372 791,792

d.

Read the air pressure value from the Data List.

HINT:
·

Standard atmospheric pressure is approximately 101 kPa (abs) (15 psi (abs)).

·

For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.




e.

Using a vacuum pump, set the NO. 1 turbo pressure sensor.


f.

Using a vacuum pump, read the value when pressure is applied and when pressure is decreased.

OK:

The pressure values when applying pressure or decreasing pressure using the vacuum pump and the Data List values are nearly the same.


NOTICE:
·

Do not apply a pressure of 50 kPa (0.5 kgf/cm2, 7.3 psi) or more to the NO. 1 turbo pressure sensor.

·

Do not apply a vacuum of 50 kPa (375 mmHg, 14.8 in.Hg) or more to the NO. 1 turbo pressure sensor.



HINT:

The pressure value displayed in the Data List is the pressure value indicated on the vacuum pump with the air pressure value added.

Example:
Vacuum Pump Pressure Value Air Pressure Value Equation Data List Value
When vacuum is applied at 30 kPa (225 mmHg, 8.86 in.Hg) 100 kPa (1.0 kgf/cm2, 15 psi) -30 + 100 = 70 70 kPa (0.7 kgf/cm2, 10.2 psi)
When pressure is applied at 20 kPa (0.2 kgf/cm2, 3 psi) 20 + 100 = 120 120 kPa (1.2 kgf/cm2, 17 psi)