Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0467377 POWER STEERING OIL PRESSURE SWITCH G

V35A-FTS ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89448A 1.INSPECT POWER STEERING OIL PRESSURE SENSOR

a.

Check the power steering oil pressure sensor.

i.

According to the display on the GTS, read the Data List.

Powertrain > Engine > Data List
Tester Display
Power Steering Pressure
50003 372 518

ii.

Start the engine.


iii.

Operate the steering wheel while idling, and read the value on the GTS.

Standard:
Measurement Condition Specified Condition
Power steering not operating 0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi)
Power steering operating Values change from above value


If not as specified, check for DTCs.

If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure sensor.

Inspect the power steering system.

Click hereSteering>POWER ASSIST SYSTEMS>VANE PUMP (for V35A-FTS)>ON-VEHICLE INSPECTION

If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure sensor.