Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467385 CRANKSHAFT POSITION SENSOR G

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11401G 1.INSPECT CRANKSHAFT POSITION SENSOR

a.
A168904C06
1.51,0.688 1.917,0.927 0.406,0.24 0.135,0.125 0.427,0.427 0.292,0.302 10 false *a 1.583,0.719 1.875,1.021 0.292,0.302 10 false C68
*a Component without harness connected
(Crankshaft Position Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C68)Location & Routing

Click Connector(C68)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Crank Position Sensor

C68-1 - C68-2 Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω


NOTICE:

In the table above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.