89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR
Partially immerse the engine coolant temperature sensor in water and warm up the water.
| *a | Component without harness connected (Engine Coolant Temperature Sensor) |
*b | Resistance |
| *c | Temperature | *d | Acceptable Range |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(C84)Location & Routingewd_type=routing;type=c;code=C84 |
||
| C84-1 - C84-2 | Approximately 20°C (68°F) | 2.32 to 2.59 kΩ |
| Approximately 80°C (176°F) | 0.310 to 0.326 kΩ | |
If the result is not as specified, replace the engine coolant temperature sensor.
When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the sensor dry.