Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › KNOCK SENSOR
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467388 KNOCK SENSOR G

1GR-FE ENGINE CONTROL  KNOCK SENSOR  INSPECTION  


PROCEDURE

Hide 89615 1.INSPECT KNOCK CONTROL SENSOR

a.
A294030C09
2.052,0.198 2.458,0.385 0.406,0.188 2.052,0.438 2.458,0.625 0.406,0.188 1.208,0.073 1.521,0.229 0.313,0.156 10 false *a 2.094,0.219 2.479,0.417 0.385,0.198 10 false C103 2.094,0.448 2.49,0.646 0.396,0.198 10 false C102 2.5,0.198 2.813,0.354 0.313,0.156 10 false *A 2.5,0.427 2.813,0.583 0.313,0.156 10 false *B
*A for Bank 1
*B for Bank 2
*a Component without harness connected
(Knock Control Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance (for Bank1):
Tester Connection Condition Specified Condition

Click Location & Routing(C103)Location & Routing

Click Connector(C103)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Knock Control Sensor (Bank 1)

C103-1 - C103-2 25°C (77°F) 120 to 280 kΩ


Standard Resistance (for Bank2):
Tester Connection Condition Specified Condition

Click Location & Routing(C102)Location & Routing

Click Connector(C102)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Knock Control Sensor (Bank 2)

C102-1 - C102-2 25°C (77°F) 120 to 280 kΩ


If the result is not as specified, replace the knock control sensor.