Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467390 HEATED OXYGEN SENSOR G

1GR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A489158C01
1.531,0.49 1.927,0.677 0.396,0.188 1.531,0.24 1.927,0.427 0.396,0.188 0.885,1.573 1.344,1.573 true 2.063,1.146 2.521,1.146 true 0.906,1.156 1.365,1.156 true 2.573,1.052 3.146,1.219 0.573,0.167 10 false HT1B*A 2.573,1.25 3.125,1.438 0.552,0.188 10 false HT2B*B 0.052,0.052 0.25,0.208 0.198,0.156 10 false *a 0.656,1.083 0.885,1.292 0.229,0.208 10 false +B 0.656,1.479 0.875,1.667 0.219,0.188 10 false E2 1.583,0.51 1.917,0.698 0.333,0.188 10 false C86 1.583,0.26 1.896,0.427 0.313,0.167 10 false C85 1.979,0.24 2.292,0.438 0.313,0.198 10 false *A 1.979,0.5 2.292,0.698 0.313,0.198 10 false *B
*A for Bank 1
*B for Bank 2
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance (for Bank 1):
Tester Connection Condition Specified Condition

Click Location & Routing(C85)Location & Routing

Click Connector(C85)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Oxygen Sensor (Bank 1 Sensor 2)

C85-1 (HT1B) - C85-2 (+B) 20°C (68°F) 5 to 8 Ω
C85-1 (HT1B) - C85-4 (E2) Always 10 kΩ or higher


Standard Resistance (for Bank 2):
Tester Connection Condition Specified Condition

Click Location & Routing(C86)Location & Routing

Click Connector(C86)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>No. 2 Oxygen Sensor (Bank 2 Sensor 2)

C86-1 (HT2B) - C86-2 (+B) 20°C (68°F) 5 to 8 Ω
C86-1 (HT2B) - C86-4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.