Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH
RM38G0E _51 Engine / Hybrid System _100527 1GR-FE ENGINE CONTROL _0467391 POWER STEERING OIL PRESSURE SWITCH G

1GR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438D 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the power steering oil pressure switch.

Powertrain > Engine > Data List
Tester Display
Power Steering Pressure
50003 372 518
i.

Start the engine.


ii.

Operate the steering wheel while idling, and read the value on the GTS.

Standard:
Measurement Condition Specified Condition
Power steering operating Values change from above value
Power steering not operating 0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi)


If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

Inspect the power steering system.

Click hereSteering>POWER ASSIST SYSTEMS>VANE PUMP (for 1GR-FE)>ON-VEHICLE INSPECTION

If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.