Home › General › SETUP › WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL
RM38G0E _V1 General _100548 SETUP _0467441 WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL F

SETUP  WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL  AUTOMATIC LEARNING CHART  


AUTOMATIC LEARNING PERFORMED WHEN CABLE IS DISCONNECTED/RECONNECTED TO AUXILIARY BATTERY TERMINAL


When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -