| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
The ECU of this system is connected to the CAN communication system.
Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs.
Check for freeze frame data.
Record or print DTCs and freeze frame data if necessary.
Clear the DTCs and freeze frame data.
Recheck for DTCs.
Simulate the malfunction condition and check if the DTCs are output again.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
Click hereDrivetrain>JF2BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
Terminals of ECU
Click hereDrivetrain>JF2BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>TERMINALS OF ECU
Data List / Active Test
Click hereDrivetrain>JF2BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT