COMBINATION METER ASSEMBLY
Disconnect the I5 combination meter assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| I6-6 (B) - Body ground | +B power supply | Always | 11 to 14 V |
| I5-1 (EP) - Body ground | Ground | Always | Below 1 Ω |
| I5-5 (B) - Body ground | +B power supply | Always | 11 to 14 V |
| I5-2 (ET) - Body ground | Ground | Always | Below 1 Ω |
| I5-33 (LA/B) - Body ground | Ground | Always | Below 1 Ω |
| I5-6 (IG+) - Body ground | IG power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V*1 10.5 to 16 V*2 |
*1: w/o Stop and Start System
*2: w/ Stop and Start System
Reconnect the I5 combination meter assembly connector.
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| I5-13 (CANH) | CAN communication line | - | - |
| I5-30 (MSCL) | Local bus communication line | - | - |
| I5-7 (FV) - Body ground | Fuel sender gauge (Power source) | Ignition switch ON | Pulse generation (See waveform 3) |
| I5-24 (FV) - Body ground*1 | Sub fuel sender gauge (Power source) | Ignition switch ON | Pulse generation (See waveform 3) |
| I6-18 (SI) - Body ground | Speed signal for other system (Input) | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| I5-17 (FE&B) - Body ground | Fuel sender gauge (Ground) | Always | Below 1 Ω |
| I5-34 (FE) - Body ground*1 | Sub fuel sender gauge (Ground) | Always | Below 1 Ω |
| I5-29 (CANL) | CAN communication line | - | - |
| I5-14 (MSCH) | Local bus communication line | - | - |
| I5-9 (CXPI) | CXPI communication line | - | - |
| I5-23 (FR) - I5-17 (FE&B) | Fuel level signal | Ignition switch ON, fuel level full → low (fuel level warning light on) | Pulse generation (See waveform 2) |
| I5-8 (FR) - I5-34 (FE)*1 | Sub fuel level signal | Ignition switch ON, fuel level full → low (fuel level warning light on) | Pulse generation (See waveform 2) |
| I6-35 (+S) - Body ground | Speed signal for other system (Output) | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| I6-23 (BKL) - Body ground | Driver seat belt buckle switch signal | Driver side seat belt fastened | Below 1 V |
| Driver side seat belt unfastened | 11 to 14 V | ||
| I6-7 (RRBT) - Body ground*2 | Rear No. 2 RH seat belt buckle switch signal | Rear No. 2 RH seat belt fastened | 11 to 14 V |
| Rear No. 2 RH seat belt not fastened | Below 1 V | ||
| I6-21 (RLBT) - Body ground*2 | Rear No. 2 LH seat belt buckle switch signal | Rear No. 2 LH seat belt fastened | 11 to 14 V |
| Rear No. 2 LH seat belt not fastened | Below 1 V | ||
| I6-10 (OILW) - Body ground | Engine oil level signal | Ignition switch ON, engine oil level not low | Below 1 V |
| Ignition switch ON, engine oil level low | 11 to 14 V | ||
| I5-21 (S) - Body ground*3 | Oil pressure signal | Engine not started | Below 1 V |
| Engine started | 11 to 14 V | ||
| I6-9 (LP) - Body ground | Security indicator signal | Security indicator light off | Below 2 V |
| Security indicator light blinking | Pulse generation | ||
| I5-20 (ODO) - Body ground | ODO/TRIP switch signal | Ignition switch ON, ODO/TRIP switch not pushed | 4 to 6 V |
| Ignition switch ON, ODO/TRIP switch pushed | Below 1 V | ||
| I6-17 (HZSW) - Body ground | Hazard warning signal switch signal (Output) | Hazard warning signal switch off | 11 to 14 V |
| Hazard warning signal switch on | Below 1 V | ||
| I5-11 (SAT1) - Body ground | DAC/CRAWL switch indicator signal | DAC/CRAWL switch indicator off | 11 to 14 V |
| DAC/CRAWL switch indicator on | Below 1 V | ||
| I5-28 (SAT2) - Body ground | MTS switch indicator signal | MTS switch indicator off | 11 to 14 V |
| MTS switch indicator on | Below 1 V | ||
| I5-27 (SAT0) - Body ground | Drive mode select switch indicator signal | Drive mode select switch indicator off | 11 to 14 V |
| Drive mode select switch indicator on | Below 1 V | ||
| I6-12 (SYC1) - Body ground*4 | Backward vehicle approach warning function signal | Approach warning function OFF | 11 to 14 V |
| Approach warning function ON | Below 1 V | ||
| I6-2 (TRNR) - Body ground | Rear turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| I6-1 (TRNL) - Body ground | Rear turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| I6-5 (LR) - Body ground | Front/side turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | ||
| I6-14 (LL) - Body ground | Front/side turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V |
*1: w/ Fuel Sub Tank
*2: w/ Rear No. 2 Seat Belt Warning
*3: for 1GR-FE
*4: for Sequential Type Turn Signal Light
If the result is not as specified, the combination meter assembly may be malfunctioning.
Waveform 1:
| Item | Condition |
|---|---|
| Tester connection |
·
I6-18 (SI) - Body ground
·
I6-35 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON, wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
Waveform 2:
| Item | Condition |
|---|---|
|
*: w/ Fuel Sub Tank |
|
| Tester connection |
·
I5-23 (FR) - I5-17 (FE&B)
·
I5-8 (FR) - I5-34 (FE)* |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON, fuel level full → low (fuel level warning light on) |
(A) will differ depending on the fuel level.
Fuel level full: 4.2 to 4.6 V
Fuel level low (fuel level warning light on): 0.3 to 0.7 V
Waveform 3:
| Item | Condition |
|---|---|
|
*: w/ Fuel Sub Tank |
|
| Tester connection |
·
I5-7 (FV) - Body ground
·
I5-24 (FV) - Body ground* |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON |
Ignition switch ON (4.5 to 5.5 V)